Recent content by kripton

So I guess I am just to timid, taping the u joint with a 2# sledge got it out. Thanks again. Posted from the TurboBuick.Com mobile app

I was afraid of damaging the casting I will continue to pull and tap on u joint with some prying and see where I get. Thank you for your ideas Posted from the TurboBuick.Com mobile app

Just pulled ( my first) my engine/trans/ drive shaft to day yes all three at once. The slip yoke would not come out. We tried a pry bar, hammer, attached a come along to the rear and anchored behind the car. It never moved. Any ideas how to remove the slip yoke. It's an 85 everything factory...

Got the throttle body put back on this weekend and started her up. noticed that the exhaust smoke was coming out the header side of the turbo ( exhaust side). I then noticed there was no exhaust coming out the tail pipe. So I ended taking off the cat and found a mouse nest and cat to be broken...

Thanks everybody for the replies this gives me options of what I can do. Is there enough room to leave the mounting brackets for the split bench and add the new brackets for the bucket? In case I would want to change back? Or would this end up being a custom fabricated bracket.

Has anybody taken a car with split bench set up and switched it to a bucket seat setup? What would I need...... DS & PS Seats and seat rail brackets Console and console mounting brackets Steering column My drivers side floor pan is rusted out and I will have to replace that not sure if the...

Thanks but i already got it striped down, cleaned and put back together. I am going to attempt to drop the gas tank tomorrow.

Oil changed, new battery, coolant changed, Had a hard time trying to siphon out the gas, I will probably have to drop the tank this next weekend to get it all out. My throttle body had so much corrosion that the gas petal would not move, currently torn apart and in the process of cleaning...

With work and a baby on the way I have delayed the start up project hopefully this weekend.

My 1985 T-Type has been sitting for 4-5 years. Other than replacing all fluids, battery, and exterminating the mice out of it. Is there anything else I should do before I try and start it?

I will be taking orders for the next run of this part. If you are interested Please let me know I am not shure on the time line when these will be done yet. But I will keep you up to date. Thanks, Daniel

Sent PM Thanks,

FINALLY!! I have The parts. I only have a limited supply!! If you are interested please send me a PM. Thanks, Daniel

I will let you guys know when the parts are finished.

We are tooling up for anouther run if you are interested in one or two of these fine inlet bells please PM me. We will be asking $30 + shipping included will be the upper and lower O-ring. I mounted the prototype up to my car a cupple weeks ago and it fit perfectly. If you have any question...