Recent content by Jason dcpt

Who makes a real nice one for our cars? Car is a drag only vehicle. Thanks

Really? Bruce is a good guy.

Where were you watching the 340 build? I'm a fan of those engines

I had to change my name recently for some reason. Shows me as a new member but I've been here for like 15 years probably more.

Where you located and what's your price range?

I think the measurements he gave me was 3 1/4 inch maybe

Is that a bhj balancer? When you set it up 60 degrees btdc did the crank sensor align with the red mark on the pulley? Mine didn't and I am not close to starting the car yet just wondering if the measurements Cruze gives is just to put it in the ballpark.

Yes I understand

Can I ask why so set on these particular parts?

I'm pretty sure I know who stage 1 is. I won't say anything about it.

Your math was dead on and I contacted Don for confirmation. And with a bhj balancer its 3.25

Will do. Thanks again for the info

Bhj

Installing a dominator efi. Is there a way to do this without putting a degree wheel on the front of the engine?

They are on a massive back order at the dealer last one I installed took a couple months to get.