Recent content by HOFSGNX

Does anyone have a wiring schematic for hooking up the stock radio head unit to the power antenna? Also, where is a good place to get a replacement complete power antenna as mine is shot.

Got the same problem in that my light does not work - it's grounded with a fresh bulb and will not turn on, possible solutions???

I have the GNX fender flares and was wondering how hard it is to roll the lip of the stock fender underneath the aftermarket flares? Also, do the 315 45 R16 tires bulge on a 10" wide wheel or is that wide enough? How do you adjust your speedo for the taller tire?

Ok sounds like I need to go a bit wider to the 10" wheel. What kind of tires? How tall are they?

Are you using the GBody Parts GNX 9.5x16 wheel with P315 45R16 tires - any fitment issues? - what kind of tires?

Does anyone have any information on GNX 288, its history, previous owners, any details would be great - thank you

Just wondering if the GNX is still for sale

Is this car still for sale

no chip it is the FAST e 85 system

Just got done going through the motor (roller rockers, stroker kit, rotating assembly, etc) and after re-installing the motor it starts right away but then immediately kills. I have the FAST E85 system. Everything worked great before we pulled the motor. Is it something simple that we are...

What is the correct center cap?

Did you ever get the problem figured out - low 02 readings at WOT - I am having the same problems - o2 readings in the 200's at WOT

How about using that combo (mothers and steel wool) on the VC's or do we have to take them off and get them powder coated as the only solution to clean them up?

72 Firebird your car looks great inside and out. One thing that no one has commented on is how did you get your AC up near the passenger-side firewall to look so good? It almost looks like stainless. Also, how hard was it to get your VC's powdercoated?

72 Firebird, the parts should be in this week from John's Performance, so if you can make it work that would be great! Double checked the area and did not see any seal out in that area. John validated the oil check tube as where the oil most likely came out.