Recent content by grayt

Thanks guys i will have to go take the one off my moms(yeah my moms) gn and try it on the t

Anyone know what this is? Car won't stay running and backfires.

I purchased a set of these so called headers from ssautochrome to replace my leaky stockers. They didn't fit and leak worse than cracked stockers. the 3' downpipe needed to be dented and the bolts they sent with is were stainless and galled up when i tried to remove. I would highly recommend...

Started my 86 last week and it quit right away. Checked the fuel pressure and it was at 0, so jumped it across the hotwire relay and it started right up. There is voltage at the relay and it has a good ground but no voltage coming from the trigger to close the relay.

Driving home last night and got into the long skinny pedal and noticed at first the headlights got real bright(because of the volt blaster i imagine) but then the went dim and the motor kind of bucked. I tried it again and flipped the scanmaster to volts and watched it and after about...

Just installed SSautochrome headers on my car and it was an easy install. Had to make some room for the houston pipe but very little damage to the headers. The quality was good and all accesories fit without a problem.Have noticed alittle more lag but i am running a reds chip with a 63e. One...

Would like to upgrade from 009's that i used with my ta61 to aset of 60# injectors to use with the te63e i just bought. Any advice for where to buy injectors and chip.

Just changed the crank sensor on mine today. There is a small bolt that pulls the aluminum together to hold sensor. Loosen the bolt and remove sensor, install the bracket and then slide the sensor into bracket. This will allow you to space the sensor away from the flag on the crank then tighten...

Traced problem to the crank sensor. Replaced it with partsource over the counter instock sensor and started right up

Help no Spark Checked all hose connections and wiring connections, seem to be ok. All fuses under the dash are fineand there is lots of fuel pressure. How can i check the crank sensor?

Pulled car out of storage and went for a drive. got into alittle boost and everything was ok. Took car home and washed it. Restaarted and went to blow water of car and got into some boost , loud pop and engine died. Won't restart, lots of fuel pressure but nothing at all? Any ideas i don't have...

Just talked to the tech at TA and he told me 2 weeks for delivery on a set of stainless headers. Does this sound right or am i going to put my name on a list and wait months. My stock headers have been welded and ground but still won't stop leaking . Ive had enough and just want to replace them.

Thanx guys its been a while since my buick has been out and your info is appreciated. The car has gone 11.53 with the ta60 and i'm hoping for low 11's out of the 63. What is the hot new chip to go with these motoron 60's?

best place to buy??

Updated my ta60 with a te63e and was wondering about a new set of injectors. 42.5#'s are in the car now but get kind of lean up top. Any suggestions?