Recent content by gmturbo

I have a set of 2.5 pitbull mufflers clean no damage

where can you purchase the aerochambers?.5 inch?

sick i realize that I have had a stroke and I am clinically paralyzed very hard to type:confused:

Oil pressure readings below 20 psi hot means the engine needs bearings refreshed?

What are some of the members oil pressure readings (hot) on a 3.8 motor? I have seen some engines 20psi hot and some even down around 10 psi. Once the car temp cools down oil pressure increases. Are stand-alone oil coolers beneficial or is this a sign of bottom end wear ????

I was wondering who supplies/makes these rims for the GN? thanks

thanks for your feedback

I'm looking for feedback on the engine gasket sets most of you are using when doing an engine rebuild. I have a leak from my front timing cover crank seal and want to know if it is better to use the fel-pro set (TCS45930) or to stick with using the gasket from the factory (GM). I know these...

I know this may have been asked before but I think Buick vendors come and go and sometimes tell you what you want to hear over the phone to get your business. We get our build-up home and the support disappears :confused: Who are the vendor(s) who are building and tuning Stage 2 motors and...

Hey Cheeseburger, email me or send me a private pm. I am interested in this motor Conrad

Local pick-up is no problem

I sent you a PM

I didn't get your PM yet?

4.1 on-center block (new) purchased at GM Motorsports , the block is machined and ready to go. Brand new J.E. piston's for the block (still in the box) 3.625 motorsports crank 10/10 checked and ready to GO 6.5 carillo rods Duttweiler...

Hey Norbs, is your car running yet? Do you plan to attend any Buick events with your car this year?