Recent content by frankunderpsi

HI Buddy, Check your e-mail...

:) Scott check your e-mail.....I'll take the converter when it comes out. Frank

Dreweter, Mine did the same thing when the pump in the converter (form the texas ac )departed and killed the whole trany .....hope You have better luck.....time to pull the pan and look :frown:

the 86 5.0 was the first Ford TPI type set up no roller cam 200hp auto 215hp 5sp , in 87 the HO 225hp and rollercam Small volume heads, 87 mustang got the truck heads form 86model 86 had the 7.5 rear , they didnot get 8.8 till 87 first year of third brake light 86 gt body...

Drew if the tire shop used to much tire soap or the wrong type of lubercant. When mounting the tires ,they may have rotated on the rims. Just get them rebalanced I always use a tire marker from under the car and make and index mark on the tire and rim after the new tires are installed so...

wire conectors 1 oli sending unit 2 power master brake motor + pressure switch 3 power antena for radio

GBODYPARTS.COM is also a vendor for them

call Jack Cotton...when I was at his shop last week he was on the phone ordering some in..form FAST I have the same problem too. new laptop and no serial port and xp

next_level is right ..1.55 is the rocker ratio now to figure what the valve lift is ...this is what you need to do cam lobe lift from the cam card times the rocker ratio equals the valve lift .. example : .300 X 1.55 = 0.465 This is your gross valve lift your really alittle...

I think 1979 Pontiac sunbird had 3.8 w/ 4spd also look @ chevy monza and vegas hope this helps

yes ! Ben you need LCA Paul recommended his frame braces on my car so I do not rip the LCA out and put them thru the rear seats !! OUCH

Is anybody using one of these yet? Are there any improvements over a ported stocker and RJC power Plate? TIA , Frank

yes , hook it up . I went to Buick and got a NEW knock sensor for my new motor good luck !

aND YOU ARE RIGHT !!! THE WRAPPER HAD A RULER ON THE BACK

The red dot on the indian womans head is for "PUSH START " The turbin on her husbands head is for " PULL START"