Recent content by dsg

Sorry the tech assist as to the internal changes stops here... Kinda like Coke giving out the recipe ;) Good luck.. your close.. not a problem; appreciate all your help. i'll burn the lines tomorrow :) don

Thanks Razor, i'll look at that.. one quick question if you don't mind. would i be better off swapping out the valves and diaphragm to say buna and geolast or epdm and santoprene if running meth. once again thank you for your insight, don

Hi Razor; the pump is a 8000-541-236, viton valves, santoprene diaphragm. i pulled the head off to check it out and all looked well. the valves and diaphragm looked pristine. there was on debris or contamination in the pump head. i've been using a 50/50 mix of water and meth or just...

install an inject kit about four weeks ago. drove the car yesterday and had knock,would not go away. so i checked the pump and lines. well the pump will run but not prime or push any fluid. checked the diaphragm and all looks well. anybody else having problems with pump failure? has anyone delt...

I've had good luck with these guy's....................... http://www.imageshack.us/

with a proper tune on the engine, what would the plug insulators look like after three or four runs?? i.e. white and as pure as a babys but a light gray to tan or ?????????? thanks for the insight

very nice!!!

going for a new timing chain. thinking of useing the progear 3000 set. any pros or cons on these chains? thanks, don