No problems with the same setup as Dusty's. Its not to uncomon to burn a little in the exhaust or let out a pretty good pop.
You can see it in this pic the exhaust is right under the drivers feet.
Is lyode from FastFieros the guy who riped your friend off? I was just going to send my computer to Lyodes shop. My harness was already modified when I bought the car in peices, but this guy will modify them.
3800 swap harnesses - Pennock's Fiero Forum
or here is a good build thread from the...
Stage II 274ci
gn1 R Heads
47-88 turbo
Complete Wolf's setup for the rear. I think the anti roll bar is for the stirp only. They suggest you undo a end link to run on the street.
Support arm link
Hotchkis Sport Suspension Trailing Arm Mount Braces: HSS-1401 - summitracing.com
Its amazing how weak our frames are even before being notched. Couldn't resist the last pic. It's so close to being started.:biggrin:
Here's pics of our frame notched and boxed. Used .125 for the mid section and .187 for the replacing the notched piece. Hope it helps.
http://www.turbobuick.com/forums/general-turbo-buick-tech/205473-frame-notching-bracing-ideas.html
I don't know how to get him out to the track. When I had my car I teased him about kicking his butt with my stock motor, but that still didn't get him out. I don't think he'd push it very hard anyhow. Its just to nice.
Those are some sweat hp #. Got a question for you guys. When running a car with this amount of horsepower I would assume that you would run a elec. boost controller. So my question is being that it is blow thru are you able to reference fuel with boost anyhow(other than 1 lbs fuel press per 1...
That's my dad's car.:frown: New frame is ready but have alot more work to do. If anyone in the Flint area has a gn front header panel and/or fenders they will sale please pm me. Oh ya don't go to Lapeer with a 9sec car its just to bumpy. You can hear the bumps in this video .Video - Cobra vs...
With a 30" dia(94" cir.) tire and running in the 150 mph range. Does the stock wheel well have enough clearance at the front lower edge of the quarter panel if not how much clearancing is needed? Thanks