Hi Guys new to the sight so im kinda dumb on these cars. I recently put in a new engine and the car ran sweet. A month later due to over boosting I blew a gasket. I pulled the heads and replaced them . It crunk and ran fine, but then it cut off while ideling and I cant get a spark back. I purchased new crank sensor, egnition module,coil pack, and caspers cam sensor cap. My problem is I cant get the light on the new cam sensor to cut off. It seams it always sees the window. Ive taken the cam sensor drive completely out and plugged the cap to the wiring harrness to get power . I turned the gear end of the drive a complete revolution but it never cuts off. I tried this cap with a cam tool to check it and it works properly. Please help .