after start fuel

[nightdiver]

Somehow it wont go over 10%, i mean i got it tuned to add up to 35% but i see that the ecm adds just 10%
( the little dot is around the 10% area)
I did install the disket again but i got the same thing here
Got any ideas ?
Thanks

 

[nightdiver]

Anyone ?

 

[clemsgn]

Open up the dashboard and view the "Aft Corr" (Afterstart Correction) sensor. If it's not in the main dashboard, add it by clicking on File then Dashboard setup. This reading should be the actual amount of correction. The dot not being in the right place happens to me quite often. I've seen it at 0% but mostly maxed out at 80%, but when viewing the Aft Corr sensor, it's right where it should be on the afterstart vs coolant chart. I thought I had a glitch in my software also, but i haven't had a chance to re-load it yet.

Good Luck

 

[nightdiver]

Thanks ill do that
I like it when it works perfect