Search results

sold to slaphappy

sold to dannyo

ls1 sensor slappy the sensor is yours if you want it.

dannyo was the first to contact me so if he wants it, it's his

john'sperformance braided stainless oil drain tube, bought this to put on my GN, never got around to it. new in box , asking $30.00 plus shipping.

ls-1 maf sensor.GM part # 15904068, never used still in box. I believe you need a adapter harness from fullthrottlespeed to run this sensor. asking $50.00 plus shipping.

thanks for the tips. mike

I have installed ta performance headers on both driver and passenger sides with no issues, just one quick question about cross over pipe. The headers came with no instuctions but I assume the torque converter inspection cover will have to be removed? I did a quick fit test and it seems the cross...

bought mine from gbody parts. Works fine, no leaks with ultra copper sealant.

back fire I will check coil packs/plugs and I will get a boost gauge asap. thanks for the suggestions. mike

My car is backfiring out the exhaust at full throttle. It idles a little rough but not that bad. It runs fine other than wot, If i ease into the throttle slow and steady boost kicks in and it takes off fine. I have just installed 009 injectors with turbo tweek street chip for 93 octane. my mods...

pcv valve I got it on ,was a pain . thanks for all your help. thanks,mike

How far do you push pcv valve into the rubber gromet on the intake. I just don't see how the pcv valve will fit to the fat part of the pcv valve where the lip is. If this is how it is are their any tips on doing this. thanks, mike

I just put new 009 injectors in with matching turbo tweek street chip. I also installed bop engineering angle boss to clear big mouth 31/2 mass air pipe. The car won't start unless I push down the gas pedal a little bit. My iac count starts at 175 and goes all the way to 0 and will not move...

I droped tank to change fuel pump and wanted to clean inside/outside of tank while I had it off. The tank is a little rusty on outside but I think I can clean it up nice and paint it. When I was tipping tank over to get all the old gas out I noticed something rattling around. The noise ended up...

My GN has 157,000 miles on it and I don't know the history of it. It has a miss at idle and stutters at wot. It runs fine in between idle and wot. If I mash the pedal it stutters, if I slowly push the pedal to the floor it accelerates fine.I have checked and changed the basic stuff.(other than a...

I can not get the cam sensor out in order to put a new one in. I have the balancer at 25 degrees atc the #1 cylinder at tdc . The cam sensor hold down bolt is removed and the the cam sensor cap is off and the window is facing the driver side fender. I am pulling on the sensor but it will not...

I have a 87 gn project car (157,000 miles) that I am trying to get running properly. I have no scan tool but I have replaced plugs,wires.iac,tps.ign module,coil pack,ecm. The car idles rough and has a miss at idle, wot it falls on it's face. I have suspected the cam sensor so I upuged it while...