Search results

wont start Hey guys I figured it out. Turns out I have a wire pinched in the loom that goes to the ignition module. I did a good search over all of the wiring harness and noticed a pinched spot on the green wire in the ignition module harness which I may have done while installing head gaskets...

Won't Start I checked the orange ecm wire on the ecm end with an ohm meter and its saying 12 volts.

Won't Start I also noticed before I pulled the cam sensor drive from the engine when I tried to start the car I wouldnt see any readings in the scanmaster.It would only show the 2.1 on the screen.

Won't Start After I pulled the cam sensor drive and turned the gear end by hand to see if the window was turning .It was turning properly.I even checked the ccci , engine , and all other fuses under the dash.

Hi Guys new to the sight so im kinda dumb on these cars. I recently put in a new engine and the car ran sweet. A month later due to over boosting I blew a gasket. I pulled the heads and replaced them . It crunk and ran fine, but then it cut off while ideling and I cant get a spark back. I...

First of all Id like to say hello to all of the club members . I am new to the site and looking to gain some nouledge on the fast cars. I am kinda confused on the tuning devices . I have not figures out what system is the simplest to work with . Im not all that smart with programming. Needing a...

First of all Id like to say hello to all of the club members . I am new to the site and looking to gain some nouledge on the fast cars. I am kinda confused on the tuning devices . I have not figures out what system is the simplest to work with . Im not all that smart with programming. Needing a...