Hello everyone!
I am new to this internet conversation process, and I am also new to working on cars. Thanks to debigguy for pointing in the right posting direction.
I have a 1987 Buick Grand National, I pulled the old transmission (200-4r), i.e., I removed everything associated with the tranny to get the tranmission out of the car. I purchased a remanufactured one (200-4r). I re-installed the tranny to the engine using six bolts.
My problem is I cannot re-install the crossmember because the tranny sits too low, and i still need to attach the tranny rear bracket that fits into the crossmember; again the only thing I have done so far is attach the tranny to the engine.
Any suggestions will be appreciated.
I am new to this internet conversation process, and I am also new to working on cars. Thanks to debigguy for pointing in the right posting direction.
I have a 1987 Buick Grand National, I pulled the old transmission (200-4r), i.e., I removed everything associated with the tranny to get the tranmission out of the car. I purchased a remanufactured one (200-4r). I re-installed the tranny to the engine using six bolts.
My problem is I cannot re-install the crossmember because the tranny sits too low, and i still need to attach the tranny rear bracket that fits into the crossmember; again the only thing I have done so far is attach the tranny to the engine.
Any suggestions will be appreciated.