Precision TA 6262

[bobs84ttype]

http://www.precisionturbo.net/Stree...treet-and-Race-Turbocharger---TA6262-CEA®/237
Anyone have experience with this turbo? ... I am looking to adapt this to a hot air application.

 

[aminga]

It's a 6262 in a stock appearing housing. It looses a little with the compressor cover but not much

 

[Jerryl]

Not sure if you are aware . . . The turbo will need a different seal to work on a HA.

 

[bobs84ttype]

Yes aware there must be different seal. Because compressor has negative pressure when throttle valve closes .

 

[34blazer]

Bob, I have one. If I can find some time Ill bring my car over and let you check it out, and take a quick spin.

 

[aminga]

The bolt on bell is also slightly larger than an old school TA series turbo

 

[bobs84ttype]

The bolt on bell is also slightly larger than an old school TA series turbo

That is good information . I was wondering about that. I called precision to see if they had external dimensions. Said they would look for some and send e mail. My plans are to cast a larger throttle body to match the larger compressor opening. Will have to address the larger mounting surface also.