Tim Cucci
Member
- Joined
- May 24, 2001
I have just finished the engine rebuild. Old stock cam, lifters, and pushrods went back just like they came out. New rings and all new bearings. Old pistons, rods, and crank reused but reconditioned. All bearing clearances were less than .002". I have a new stock oil pump and get 22 psi oil pressure at hot idle and instant oil pressure response up to 60 psi while driving. I am baffled at the small amount of oil that actually comes out of the pushrods and reaches the rockker arms. It is barely a dribble from the pushrods. Is this normal ? Scares me.
Thanks
Tim
Thanks
Tim