Low Budget
Member
- Joined
- Apr 10, 2002
I have no high speed. The resistor coil looks like new. I can make the blower run on high speed if I jump the orange to purple at blower relay connector. Fine I thought. The relay must be bad. So I put a new one on, and the high speed still doesn't work. I tried previously to jump the orange and brown/white wires at the switch, and that didn't work, so the switch at least was not the only problem if at all. The wires check out ok between the switch and the blower resistors. What am I missing here. There is a control problem somewhere, because I can make the blower run on high, as stated earlier, by jumping past the relay. The switch must be on high for this test to work, so there's a second check for the switch. It should be good. Is there a componant I am leaving out? Anything tied through the A/C? I have good cold air, now I'd like to feel it with a bit more velocity! I have schematics, and I just don't see anything else tied in here. Maybe I need to check the black (ground) leg going to the relay connector. I'll trace that back to ground tomorrow. I guess that could give me trouble. If anybody can jump in meanwhile, that'd be great!
Thanks,
Jeff
Thanks,
Jeff