Closing off vacuum ports

[85Dan85TType]

Hey guys, I have the GBodyParts vacuum block (w/ the port for vac brakes), and I'm not using 3 of my ports, so how can I block these off without putting a screw in the end of a vac line and making it look like hell? These seemed like very small fine fittings. Any help greatly appreciated!

-Dan

 

[Bweavy]

Hey guys, I have the GBodyParts vacuum block (w/ the port for vac brakes), and I'm not using 3 of my ports, so how can I block these off without putting a screw in the end of a vac line and making it look like hell? These seemed like very small fine fittings. Any help greatly appreciated!

-Dan

Dan I'll get you thread sizes in the AM if you want to block them off. Or on the next run I can get them to leave them blank for you & we can just swap them out. E-mail me if I can help. They are built a few blocks from my shop.

 

[85Dan85TType]

Much appreciated sir!