Search results

I have a complete 84 Regal hardtop, 57k miles for sale located in Westchester county, NY. I bought the car to use as a donor for my 86 GN but never got around to it. The car is rust free except for some surface rust on the roof by the drip rails, and the bottom of the passenger side door. The...

So my gn has been off the road for almost 2.5 years now, it started as a little rust repair and before i knew it the car was stripped down to a bare shell and frame, at which point I couldn't decide if it was worth it to continue or not. So far I haven't had much luck in finding a rust free gn...

1G4GM47AXFH401943 Thanks, Tom

I'm looking for suggestions and opinions on a couple amps and speakers i'm considering upgrading to. I've currently got diamond m6's (i think) and an mtx sub running off an alpine amp. My main focus of the upgrade is the sub. I'm pretty much considering a jl 10" w6v2, and running it off a jl...

Was wondering if someone out there with an account could run this vin for me? 1G4GJ1174HP420291 Thanks, Tom

1G4GJ1179HP432498 Thanks, Tom

I'm in the process of building a new engine, girdled 4.1 production block, fwiw. I'm curious about pros and cons of running either tight or loose main and rod clearances and what the general consensus is around here. I've seen some info saying running these motors on the loose side is about...

Ran my T108, no stutter, no lockup, for the first time at the track this weekend. When I would stage it would seem to stutter or hit a rev limiter at 1500 rpms. I'm not sure what the stutter is supposed to feel like, but I would have expected it to hold the rpm steadier, this bounced between...

I noticed my car doesn't seem to be locking up anymore, occasionally it would feel like it would engage, but when stepping on the gas it still didn't feel locked. I tried locking it up full time (shorting the aldl connector with a paper clip). Manually shifting the shifts were harder and had a...

.... how the intermediate servo works? whats the function of the inner and outer piston, and what effect would removing the inner spring, and inner piston seal have? They were part of the installation instructions for a manual vavlve body. I ask because of my recent problems in dealing with...

I'm putting my BRF valve body back in, after my continuing disaster with a manual valve body, when I noticed theres only 2 check balls in the valve body side. The #8 check ball (1-2 shift valve) isn't there. I couldn't find any mention of having only 2 check balls on the valve body side in any...

I recently installed a TCI rev manual valve body, about a week after, I noticed it sometimes getting difficult to shift out of park, but thought it was the shifter cable binding. Last night it wouldn't come out of park at all, pulling on the shifter you couldn't feel any detents and it would...