Search results

Can you install and operate power logger on two different laptops using Windows 7 on one and windows XP on the other? I'm concerned about the drivers.

What is the best way to keep the rubber and crap off your rear fenders at the burnout box? :mad:

What is required to install a 700R4 filter in a 2004R? Are there any tricks or things to watch out for? Dan

I have a 3200 lu Vigilante TC and I am locking it with a switch. Went to the strip Friday night and couldn't get it to lock up at full throttle. I was trying to lock it at 80 mph but it would not lock. Tried it on the way home and it locked just fine. What could cause that? :confused...

I went to the strip the other night and made two runs. First run, EGT's were 1713, 02's 753, KR 0.7. Increased WOT fuel 2% with Translator and made another run. EGT's were 1714, 02's 734, KR 0.0. Static fuel pressure @ 48 PSI. This on 93 and alky. I know the 02's are a little low but my...

I just installed 60 lb Mototrons and Extender chip, now I have low AF readings @ 3 and low lv8 @ 27-28. Also, the blm's are high @ 135 at idle. This is after setting the Translator base fuel at 10% rich. I changed from 36 lb injectors and TurboTweak chip. Does anyone have any suggestions as...

My fuel pressure gage on the fuel rail shows a 5 psi difference between when it is cool under the hood and when it is warmed up. I set the static pressure at 45 psi when the engine was warmed up and it shows 50 psi when cool. I also have a gage mounted on the hood. They both read the same...

I was at the track last Saturday, made a run and noticed the tranny flared on the 2/3 shift. When going down the return road it would not shift into 2nd until about 30 mph. When driving home I found out it would shift into 2nd at 30 mph, into 3rd at 43 and a slight rpm drop at 46 mph, which is...

Will the DC Tech turbo cover fit on the new GT turbo's? Say for instance the GT6131E. Are there any other problems installing a GT turbo? I am currently running the stock turbo.

Does anyone on this board know what might cause a 200-4R tranny to not downshift to 1st gear when coming to a stop? It takes off in 2nd gear, but if I shift to neutral or park then back to drive it takes off in 1st gear and shifts properly. Whats up with that? If anyone on this board knows...

I just had a virgin BRF 2004R rebuilt by a local trans guru that has a good rep on building the 2004R's. I also installed a new 3000 stall converter. A couple of questions. Taking off at light throttle, will the 3000 stall converter mask the 1-2 shift? I can feel one shift at 16 MPH, which...

Axle bearing or Pinion I am hearing a whining noise from about 30 to 50 MPH that sounds a lot like a rear axle bearing. However, it also has a vibration when i get up over 75 MPH. Could that be the pinion bearing? Thanks, Dan