Recent content by 85ha

  1. 8

    wategate orifice?

    Does anyone know if the vacum T in line between the compressor housing, boost sol and the vacum actuator is supposed to be orificed If so what size hole is the orifice?
  2. 8

    timing cover

    I did a search and I cant find the EB timing cover mods article. Can someone please help. thnx
  3. 8

    gauge wiring

    Thanks for the link Jerryl
  4. 8

    gauge wiring

    I am installing VDO gauges on my hot air. On the oem oil sending unit there are 3 wires, I know one has to operate the light in dash but what are the other 2 wires for? Is there anything that needs to be connected to these wires after I wire in the new sending unit? I read somewhere that...
  5. 8

    chrome breathers, 3" 4" k+n filters, motor strap, 42 injectors, turbo bells

    Sent you a pm
  6. 8

    100kr?! on scanner

    Just installed comp 980 springs, 38# inj, new TT chip and ATR dp At first car would not start, so eric sent me another chip. installed it and car ran but had dead miss on number 4 I found there was no inj pulse from ecm to cyl 4. So replaced ECM under warranty. Now car seems to run fine but...
  7. 8

    4l60e forward sprag...then bind up in 4th

    More than likely a problem with forward clutch since it is applied through 1st, 2nd, and 3rd. It goes off for 4th gear and band is re applied. The coast clutch is only used for engine braking. HTH
  8. 8

    changing valve springs

    I am changing my valve springs as well. I am using the comp cams 980-12 valve springs alot of guys on here are also running these they are drop in replacements. You can also use LT1 valve springs. You can use compressed air in the spark plug hole to swap out springs or do a search on here...
  9. 8

    BIG PARTS LIST, Parting a 85GN and a 87GN Oct 2010 update

    hood shocks still available? also do you have a console ashtray? how much shipped to 75052
  10. 8

    tcc bore plug

    valve body's with the tcc bore plug are for ecm controlled vehicles. v.b's with valve train are for non ecm vehicles. HTH
  11. 8

    Egr

    pm sent
  12. 8

    Egr

    Where could I find a EGR delete plate? I am replacing my injectors and while I have the turbo off I want to remove all egr parts. I already have the 5.6v TT chip so egr function is deleted. figured a pipe plug would fit intake below turbo but I need a plate for the top intake port? Any one...
  13. 8

    Buick Parts For Sale

    pm sent
  14. 8

    Buick Parts For Sale

    Do you still have the 37lb injectors? How much?
  15. 8

    Injectors?

    Would a set of 38lb injectors be enough for my car if I want to later install a alky kit and as long as I dont go with larger turbo? Or should I go with the 009's?
See more
Top