It has been a couple years since I have pulled the GN motor but there are a lot of small things that I want to address and on the stand will be so much easier to do than in the car.
1. Fix oil leaks, again
2. Thread inserts to hopefully seal the dog house to the intake
3. Decide wether or not to use the power plate???
4. New headers
5. Fix power steering leak
6. Possibly go hydro-boost
7. Install new valve seals
8. Upgrade to SFI flex plate, not really sure if needed but a friend who has pulled his engine a few times like I have just found his cracked and that kinda scared me a little
9. Install vacuum lines at the back of the lower intake
10. Whatever else I can think of
Also picked up a 455 Buick that is now at the machine shop. That motor is going into my 85 regal limited.
Posted from the TurboBuick.Com mobile app
1. Fix oil leaks, again
2. Thread inserts to hopefully seal the dog house to the intake
3. Decide wether or not to use the power plate???
4. New headers
5. Fix power steering leak
6. Possibly go hydro-boost
7. Install new valve seals
8. Upgrade to SFI flex plate, not really sure if needed but a friend who has pulled his engine a few times like I have just found his cracked and that kinda scared me a little
9. Install vacuum lines at the back of the lower intake
10. Whatever else I can think of
Also picked up a 455 Buick that is now at the machine shop. That motor is going into my 85 regal limited.
Posted from the TurboBuick.Com mobile app