My engine was built by Conley back in the day. I thought I had the stats on the cam at one point but if I did I can't find them. All I know is it's listed as a 276/276. Anyone know the specs on that guy?
That's probably the advertised duration.
With a 1.65 rocker would be .455" lift on intake and exhaust. Mild cam, I would assume your engine is iron headed?
That's probably the advertised duration.
With a 1.65 rocker would be .455" lift on intake and exhaust. Mild cam, I would assume your engine is iron headed?
That's probably the advertised duration.
With a 1.65 rocker would be .455" lift on intake and exhaust. Mild cam, I would assume your engine is iron headed?
I was thinking .276" could have been lobe lift not degrees, not sure why I said "duration". I didn't have that card in front of me either. But either way
I was thinking .276" could have been lobe lift not degrees, not sure why I said "duration". I didn't have that card in front of me either. But either way
I only used the cam card as the example to show how to find the lobe lift. The other way is to measure pushrod or the lifter travel with a micrometer as Bison said.
That way you can at least find the lift of the cam you have without pulling it out of the motor.