What are these two wires supposed to be connected to?

[baller760]

Also, I'm trying to jump the A/C socket to tune a turbo tweak chip but jumping it doesn't seem to register to the scanmasters L8 readings to cycle from 0 to 2. How do you jump the socket properly and are these wires connected to the a/c in any way?

Picasa Web Albums - royclark24 - What are thes...

 

[krom415]

do you have a digital dash?

 

[baller760]

no. normal dash

 

[UNGN]

does your dash boost gauge work?

 

[baller760]

Kinda, but its not accurate. If I just start giving throttle it says I'm doing like 5 psi. And the stock RPM gauge is stuck at 4000 rpms but goes up when I start driving.

 

[Slow91z]

You need to show where they are coming from not just the connectors themselves, but it kinda looks like a boost sensing harness for turbolink, or something similar.

 

[forcedfedv6]

Looks like the car use to have alky injection and it was taken off..

 

[jpratt]

You need to show where they are coming from not just the connectors themselves, but it kinda looks like a boost sensing harness for turbolink, or something similar.

+1

 

[Squid4life]

You need to show where they are coming from not just the connectors themselves, but it kinda looks like a boost sensing harness for turbolink, or something similar.

X3. That is what I had.

 

[GNRick]

Could it be for the power antenna?

 

[baller760]

The power antenna works fine though. Anyway, the wires connect to a square sensor looking thing that is mounted on the area where you would put a strut bar. It's got three LED lights on this square.

 

[Squid4life]

The power antenna works fine though. Anyway, the wires connect to a square sensor looking thing that is mounted on the area where you would put a strut bar. It's got three LED lights on this square.

TPS-TEC? Basically makes sure your TPS goes to full voltage. (for folks that cannot or do not want to adjust the TPS)