Valve jobs

[dank GN]

Just wanted to share my new tool . It is basically like the newway seat cutters but it will cut the 3 angles in one pass . I just tried it for the first time today and am real happy with the results. I basically went in with a 60* grinding stone and cleaned the seat up alil then went In with this cutter . The cutter was set to the valve that was going to be used on that seat . It has a .062” seat width and a 30* 45* and 60* angle on it .

 

[earlbrown]

hand crank??? I was thinking you had a seat and guide machine....

 

[dank GN]

hand crank??? I was thinking you had a seat and guide machine....

Yea the crank works real well surprisingly. It is spring loaded So i can feel when the cutter is digging in to hard ect. So it is nice the feed back you get from it .

 

[cruzn57]

not bad, with small investment!
I guess I'm old school, I have all the stones, guides, holders, etc,
I prefer to be able to raise or lower the seat to fit the valve I'm using, and adjust the seat width ,
but as I said, "old school" ( hey I'm old, so it fits me!)LOL

 

[dank GN]

not bad, with small investment!
I guess I'm old school, I have all the stones, guides, holders, etc,
I prefer to be able to raise or lower the seat to fit the valve I'm using, and adjust the seat width ,
but as I said, "old school" ( hey I'm old, so it fits me!)LOL

Don’t get me wrong I have a bunch of stones and all that fun stuff . This tool just made it a lot faster to get a valve job done . I still use the stones to open up the stock intake seat for bigger valves .

 

[Bobs rare 6]

Nice! Any luck finding some 1.77 valves on Coltons heads?

 

[dank GN]

Nice! Any luck finding some 1.77 valves on Coltons heads?

Yea they will be here tomorrow

 

[Bobs rare 6]

Awesome! Thanks for all your help!

 

[ek02]

Who makes the seat cutter? Looks like it would be much faster than using stones. I get tired of constantly dressing stones.

 

[dank GN]

http://new3acut.com/new3acut.html
Some pics

 

[earlbrown]

Damn that pointer looks a LOT more easier to use then the one I use...

 

[dank GN]

Damn that pointer looks a LOT more easier to use then the one I use...

Yea you just have to make sure the hold down bolt is tight besides that it isn’t to shabby .

 

[earlbrown]

Yep, same with that needle pointer.