Stage II oiling ?

[turboclam]

Can I use this hole for the feed? It's the hole that's next to the front cover on the passenger side. Or is it better to use the one on the rear. The front is blocked by the intake. It's an iron 016 block if it matters. This is not my block but I copied from the board.

Thanks

 

[dr_frankenstein]

you mean where the oil pressure sensor is normally located?

I do.

you can also T the galley passage at the back of the block and add a second feed there.

I also have the same issue as you where the main front oil passage is located, my blower snout blocks its use.

Aj

 

[turboclam]

Is it necessary to "T" into the rear?
I'm trying to keep things simple. I was thinking of putting my oil pressure sending unit there on the back. Or I might "T" it in the side.

Thanks!

 

[dr_frankenstein]

not at all, the single feed on the side would be enough. I dual feed cause i do... i dont think there are any real benifits other then it gives me some kind of "peace of mind"

I know a few guys that do "T" the rear galley for a oil pressure port like your suggesting and it works fine. Slip the line up through where the knock sensor hole is and attach to your guage or sending unit.