Spark plug gap?

george harris

Member
Joined
Jun 4, 2012
I just changed my plugs from R 43TS to CR43TS, while i was changing the plugs I seen that the plug on the rear passenger side was loose. So i changed the plugs, once I started it up it is running rough. I checked the plug firing order and it seemed correct. Any suggestions?
 
What did you gap them to? try and verify that the wires are in the correct order. also inspect them maybe you pulled on a boot too hard and it ripped it from the wire.
 
What did you gap them to? try and verify that the wires are in the correct order. also inspect them maybe you pulled on a boot too hard and it ripped it from the wire.

Thanks, I checked the plug order on this site before and after I changed the plugs, I did have one plug wire that was not fully connected before I started. Would the chip have something to do with it?
 
Top