What you have to do is to pull out the top part of your rear seat and take the upper sail panel off. When you take it off you will see the nuts that holds the side windows on. When you undo the nuts you will have to pry or push the windows out. But be very careful when you do this cause you could break them. They are sealed in there. The other problem you will run into is the quarter glass from your car is different from one without the top. The black seal on the outer part of the window is larger on the cars without the top. What I mean is that if you look at your quarter glass now you will see the chrome quarter trim then you will see a black seal behing that. That is the one I am talking about. You can use that window if you want to. But that is how you take the quarter glass out. Now as far as the rear window I am not sure as I have not taken one out of a car. Are you looking for chrome trim for the rear window or the blackout trim? I have the chrome trim for the rear window but it would not be cheap. The front winshield trim for example goes for around $300 from Poston. The rear trim that I have does not have any dnts or scratches in it. When you go to pull the trim from a car in the junkyard look for a car that does not have the vynil top on it and pull the piece that is below the rear window. I mean the one that is infront of the trunk lid. I hope this info helps you out. Good luck with your project. You do have some work ahead of you.