Hey guys,
I was referred here by Street Lethal(AKA Rob from NJ), to ask for a stock LC2 timing map/Spark table for my Turbo 2.8 project. I have converted my 89 Camaro RS over to Megasquirt 1 running MSextra firmware. Also installed a T3 turbo off of a Mercedes 300SD diesel. the 300SD was a 3L, So I found that to be a good match for my 2.8L.
This is not a setup for max possible power, more geared towards being a daily driver, with a little power to back it up and turn some heads, which it has already done. Its running and driving, with little bugs here and there, that Im currently working out. Im working on the tuning and Rob said My best bet would be to work the SA off of the LC2 spark table as a better starting point then the table Im currently tuning.
I know its not a Buick, but it is a GM, lol.
Mods, if this isnt in the right place feel free to move it as I wasnt sure where to put it.
Thanks in advance for any help. Im over on the thirdgen.org forums under the same user name.
Figured Id post up the link to a video of a second start of my project. Note that this video was before I got the exhaust leaks squared away with some Remflex manifold gaskets.
Hope you enjoy!
I was referred here by Street Lethal(AKA Rob from NJ), to ask for a stock LC2 timing map/Spark table for my Turbo 2.8 project. I have converted my 89 Camaro RS over to Megasquirt 1 running MSextra firmware. Also installed a T3 turbo off of a Mercedes 300SD diesel. the 300SD was a 3L, So I found that to be a good match for my 2.8L.
This is not a setup for max possible power, more geared towards being a daily driver, with a little power to back it up and turn some heads, which it has already done. Its running and driving, with little bugs here and there, that Im currently working out. Im working on the tuning and Rob said My best bet would be to work the SA off of the LC2 spark table as a better starting point then the table Im currently tuning.
I know its not a Buick, but it is a GM, lol.
Mods, if this isnt in the right place feel free to move it as I wasnt sure where to put it.
Thanks in advance for any help. Im over on the thirdgen.org forums under the same user name.
Figured Id post up the link to a video of a second start of my project. Note that this video was before I got the exhaust leaks squared away with some Remflex manifold gaskets.
Hope you enjoy!