I went to a Danny Bee Belt drive and have to run a remote pump. Otherwise I would still be using this.What’s your reason for selling
Ok just curious I’ve been debating going this route with my new build but it will still be a street carI went to a Danny Bee Belt drive and have to run a remote pump. Otherwise I would still be using this.
AG.
Shouldn't be a problem. Running the same one on the street since about 2007. Seasonal driver but I sometimes go long distances to shows and events.Ok just curious I’ve been debating going this route with my new build but it will still be a street car
This was removed off your car in working condition with no leaks ? So I just need to put a gasket on the timing chain cover, torque every thing up. Do the seals need to be replaced or are they fine. Kit says that it comes with wiring harness and 20 amp fuse, is that still available with the pump?The pump should be fused but I had ran it direct. The instructions should be downloadable directly from Meziere. As far as the plug, there is a 2 pin weatherpack connector on the pump side and can I can provide the mating pins and connector.
https://www.meziere.com/meziere/media/Pdfs/WP125.pdf?ext=.pdf
AG.
This was removed off your car in working condition with no leaks ? So I just need to put a gasket on the timing chain cover, torque every thing up. Do the seals need to be replaced or are they fine. Kit says that it comes with wiring harness and 20 amp fuse, is that still available with the pump?
Do I use the same hose that comes from the bottom of my rad to connect to the pump in the same location?
Sorry for all the questions, I just want to know if it is pretty straight forward to install or if modifications need to be done.