Looking for some 3" tailpipes, suggestions?

[TDmkr496]

I am looking for a set of 3" tail pipes for my 87 that exit just like the factory setup does. I have looked in a few places but no such luck.

 

[NY Twin Turbo]

I am looking for a set of 3" tail pipes for my 87 that exit just like the factory setup does. I have looked in a few places but no such luck.

Just the tail pipes?

 

[TDmkr496]

Yes, I would like to fabricate the muffler forward section.

 

[robertf]

Not likely to happen. I've ask about GN1 and Pypes selling just the tail pipes with no luck. A good shop can mock up a set probably very close to stock.

 

[jbeier]

I had them on my car when I bought it. Looks like a custom job. Mine was stock downpipe to a 3" high flow cat and 3" all the way back to the muffler and 2- 3" tail pipes. Now it's 3" from the turbo all the way out. Doesn't look like it would be terribly hard to fabricate if you're already going to be doing from the muffler forward. Just buy some mandrel bends and cut and weld.

 

[Rafs-T-Type]

A good exhaust shop should be able to make whatever you need.