Installed new motor no spark

[screamindemon2]

trying to find out why no spark, put new coil & ignition module

 

[screamindemon2]

no one has had a no spark problem. What does the coil get its signal from. Something i am not getting no spark at all

 

[BW Jones]

no fire

Is your crank sensor in good shape (not damaged) and plugged in and the gap set correctly?

 

[screamindemon2]

On my scanmaster I am showing no rpm so I am going to replace tomorrow & hope to fire up

 

[Jerryl]

Good site here as well for "No Start" issues.
http://www.lakelandraceway.com/friends_garage/tr_no_start/chart_a-3_1.htm

 

[Chris Hogeland]

The crank senor has two slots see if the crank ring is going through the right one.

 

[BW Jones]

yep!

Good point Chris ........... I forgot to mention that :redface:
This is a very common (likely) error that is easily rectified.

 

[screamindemon2]

which is the right one installed new crank sensor & nothing. I had a problem with the starter wire put new terminals on all of them. Could it be a ground or something I am ready to fire it up. Thanks JoJo

 

[Chris Hogeland]

If you are standing in front of your car it will be the frist grove.

 

[screamindemon2]

On right groove , what about cam sensor being not adjusted right. What is the easyest way to check to make sure it is right.

 

[Headcutta]

Try putting the old coil & ignition module back on, I got three bad ignition modules from Advance Motor Parts on the same day.

 

[screamindemon2]

I have tryed everything got it to start shut it off & went to fire it back up to break in the cam & no fire again wtf .I am going to lose it I spent a lot of money & now got it togather & now won't start. PLEASE HELP any ideas