i'm back on the GN that die, it is the same old story, no start. Measuring voltage at B5, i'm getting 2.5 volts with switch on and will bounce around a little when cranking. New crank sensor installed and set up. Also new plug at crank sensor and wiring. NEW coil and ECM and ignition module.
All blade fuses checked ok, Voltage reading with key on read in their rating except B5 and B7 was 4 volts and no reading D5 bypass read zero instead of 4,56 volts,
Installed Caspers sensor check, key on, all three LED nice blue color, crank motor over, crank sensor LED stared blinking, but not the cam sensor LED..... not sure if this is correct.
Any help, would be very helpful, car has not been running for 10 years now. When car quite coming home from work, did all the checks and nothing, purchase another car for work.
THANK.
All blade fuses checked ok, Voltage reading with key on read in their rating except B5 and B7 was 4 volts and no reading D5 bypass read zero instead of 4,56 volts,
Installed Caspers sensor check, key on, all three LED nice blue color, crank motor over, crank sensor LED stared blinking, but not the cam sensor LED..... not sure if this is correct.
Any help, would be very helpful, car has not been running for 10 years now. When car quite coming home from work, did all the checks and nothing, purchase another car for work.
THANK.