Cross Counts ??

[richburke03]

I just installed a new denso O2 sensor and my cross counts are not jumping around like they were before at idle. All my other scanmaster numbers are dead on to where they should be. I have not driven the car since I installed the new o2. Any ideas? Oh and Im using a TT E85 chip

 

[turbo nasty]

Have you waited for it to warm up since the 02 install?

 

[richburke03]

Yes I let it idle for about 15 minutes

 

[turbo nasty]

You reset the chip before restart?

 

[richburke03]

No I did not reset the chip... I just disconnect the battery to do that right?

 

[turbo nasty]

Yeah just unplug the orange wire single cavity weather pack connector by the positive term thats the ecm feed...unplug for a few seconds and then plug back in. DOuble check your connection on your o2 sensor as well.

 

[richburke03]

Reset the chip and everything is working fine now... Thanks turbonasty!!

 

[turbo nasty]

Your welcome glad to help...for future reference its always best to reset the chip when the TPS is changed, MAF, O2, Cam sensor, plugs changed etc.