Well i finally went out and bought a boost gauge for my 87 t-top GN and go figure it doesn't fit. I bought an Autometer Ultra-lite 0-35 psi boost gauge and the autometer single gauge pod. I put the gauge in the pod and went to test fit it on the a-pillar and it high centers on the corner of the gauge. Anyone have a sucessful installation with an ultra-lite series guage?? if so what gauge pod did you use? Are there any deeper quality pods out there? Any suggestions would be appreciated.
boost gauge doesn't fit
- Thread starter pvtpilot
- Start date
salvageV6
Daily Driver
- Joined
- May 25, 2001
I've got the dual Lotek pod. with an Autometer Ultralight boost gauge.
Vacuum/Boost model.
Not exactly sure where yours is hitting?
Things that may work for you are a right angle hose fitting or else an O ring as a gauge holder instead of the aluminum bracket.
Might get you some clearance.
Vacuum/Boost model.
Not exactly sure where yours is hitting?
Things that may work for you are a right angle hose fitting or else an O ring as a gauge holder instead of the aluminum bracket.
Might get you some clearance.
Similar threads
