I ask cause im doing a rebuild and wanna get it to at least 10.8 quarter mile and was wondering in the cam and turbo I should use to get it there...its got a lot done to it though ported n published heads new valves 3 angle ground guides heavier springs 3inch exhaust 3 inch dump pipe 60#injectors cold air intake higher flow intercooler pt52 turbo fully built tranny think it its got q 3k stall converter but not sure. Adjustable fuel regulator oil and tranny cooler comp cam nitto drag radials and air bags... and I'm wanting to know can sizes and turbo sizes that work good...and can the pt52 make it to that? Is the 6152 somewhat comparable