CzyKats44
This is the way.
- Joined
- Jun 28, 2014
I'm following the GNTType steps for body mount replacement ... I lifted the back swapped out the #6 and 7s and popped in the #5s.
The body holes for the number 5 are off about an inch outboard and aft... Is this an issue if the top peg doesn't insert? The rest are still aligned. See pic.
Also, upon settling the rear back down the body is supported by the #5 and is not touching the 6 and 7 ...
Do I have to use the jack and body bolt to draw it in? See pic
The body holes for the number 5 are off about an inch outboard and aft... Is this an issue if the top peg doesn't insert? The rest are still aligned. See pic.
Also, upon settling the rear back down the body is supported by the #5 and is not touching the 6 and 7 ...
Do I have to use the jack and body bolt to draw it in? See pic