Search results

anybody rent out the tools for my 2004r build? low/revrse clutch housing tool and output shaft and rear unit support and fixture. thanks, Dennt

this is a comp. eng. steel carrier bearing cap for a 12 bolt chevy rear end. also fit my 71 vette rear end and maybe some other chevy or g.m. applications. will require drill and tap for 1/2 inch bolts. this is for the ultimate bullet proof set ups. 40.00 plus ship

this is my 2004r project. went a different direction with a different hot rod. 85 monte carlo, had about 5000 miles when i got it. was and is in very good condition. has ck valvebody kit,new in box hughes pan (hp3880),hard stator support with an extra one,extra spring forward piston...

hi. i seem to be having a problem trying to get center support play. the center support does not want to go all the way down so the snap ring will go on. it seems to bottom out on the direct drum and i cannot see the two bolt holes where the center support bolts go. i put some gear marking...

looking for a 16 spring direct drum piston retainer. thanks, denny

been away for awhile and just got around to air checking my low/reverse during final assembly. the frictions lock up when air is applied and unlock when i remove air pressure but there is also a lot of air hissing with the air on. is there an exhaust where the air exits when this test is...

hi. my direct drum on 2004r is crap. lugs are dented pretty bad. anyone in the midwest (carroll, ohio) have one for sale? thanks.

rebuilding my first 200 4r. set the end play per chris book. when i assembled everything in the case i could not get the snap ring in. clearance on the bench was .003. clearance before rebuild was .053. as i took everything back out (for the 20th time) i noticed when i pulled up on the output...

does anybody know where a person can rent a low/reverse clutch install tool for the 2004r? thanks.

hi. i'm doing my first 2004r after decades of doing the turbo 350 . i'm over the intimidation factor and i am having a hard time locating the low/reverse clutch piston wave plate. it's the small one about 3 1/2 inches in dia. in the past i got all my stuff at daaco locally. my first attempt got...

hi,i'm new here. got a 2004r and converter a few years ago. came from a 85 monte and the guy said it had about 5000 miles since a rebuild and worked great. car got t-boned and i ended up with the trans. have not opened it up yet but it passes the eyeball test. i want to put it behind a 370 horse...