Search results

Exhaust was welded at muffler so had to cut to remove. Cut the muffler outlet not the tailpipe. Need to weld new nipple onto muffler and clean up tailpipe. No shipping pickup Nassau county ny only. $400 or Bo Thanks Greg

has anyone eliminated the exhaust and just ran a small muffler and turndown right off the down pipe? or maybe no muffler at all.don't care about noise as the car is mostly track. thanks Greg

looking for a stage block, on center, thanks

These are new, sat in garage a while, includes tube of grease. $260 + ship and pp.

can it fit

2 K&N breathers for Champion valve covers. $25 includes shippind and pp.

Have for sale an older Art Carr 16930 n/l 9.5in converter with the billet cover for 200 4r. Used this converter first with a ta49 and then with a turbonetics cpt66p and it worked great with both. Stall at zero boost was 3000. $300 + pp and shipping.

lightly used turbo for sale, bought 3/08, has about a dozen 1/4mi passes and a few hundred street miles. exhaust housing is .63 a/r turbonetics that is ported for better boost control. was used with an external gated down pipe. great street/strip turbo. reason for selling, went to a cpt-70 s...

how much power could i expect to pickup running 24 to 25 psi? how off should i expect the tune to be with this swap if at all?

New oil cooler lines from Johns Performance. $75 shipped US or Canada.

Used pan for sale in very good condition. $125 shipped US or Canada. also have allen bolts to mount pan.

Mount was used for short time, converted to 400, needs to go. $75 shipped US and Canada.

Anyone running a 275/60/15 drag radial on a 15X10 rim. trying to figure out if i can run this combo without a frame notch. any input is appreciated. thanks

how much gear oil to fill 8.5 with a ta cover? Thanks

i am considering a spool setup and would appreciate any input good or bad.

i am not getting any power at the ac compressor wire. i do have power leaving the ac selector switch. where is the ac compressor relay. is there anything else i should check. the system is charged.

I am considering going with the umi upper and lower control arms. anyone out there using these please recommend which lowers are best. the uppers will be the adjustables. also can i get away with a good sway bar or do i need to consider an anti roll bar such as an H&R? thanks for any and all input.

is anyone out there using this tire offered by M&H? seems like a nice alternative to mt 275/40/17 as they are 28" tall vs MT being 26" tall. any thoughts and or pictures would be a appreciated. thanks

is anyone running 275/40/17 dr on a 17x8 wheel? some pics. looking for suggestions for sizing without frame notch.

anyone out there running 275/40/17 mt dr. if so what width and backspace wheel, frame notch and/or fender roll? thanks