Search results

Need Frame mounts for 87 limited with 307 Olds engine. Right hand Part #00559271 Left Hand Part #00559272. I have pictures of the parts if you give me an email address.

I have had fairly good luck priming the turbo and newer engines by packing the oil pump with Vaseline, but only if the engine is disassembled so you can pack the front cover passages as well as the pump itself. One time my GN lost prime due to changing some parts. I packed the oil pump with...

I need a repairable power antenna for an 87 GN with a good black mast and threaded nut. Also need a driver door body side moulding for 87 GN of the type that rivets on from factory. Price and shipping to 58103. Thanks

I am about to install a set of Airlift 1000 airbags in my rear springs. The instructions call for the tube to exit at the bottom for most GM vehicles. This seems to make it likely that the tubing is at much greater risk to damage from exhaust and snagging than exiting the top through the hole in...

After an accident, i am replacing the frame of my 87 GN with a frame from an 83 Cutlass. I am nearly ready to set the body back on the frame, but the drive shaft appears to be one-fourth to one-half inch too long. Even when forcing the driveshaft fully into the transmission, the rear u...

Two questions: Is the 20 bolt turbooil pan the same as a front wheel drive pan? Is the underdash wiring harness on a standard 87 regal the same as a turbo regal? If not what are the differences? thanks

Are 86/7 T Type wheels the same as 84/85 except for gray paint on the older ones?

I am building a 4.1 engine according to the article in Turbobuicks and am using the Edelbrock Performer cam and lifters. I am uncertain which pushrods to use as the Turbo Regal article on the history of the V6 says that in 1984 the cam base circle was changed to require .015" shorter pushrods...

I received a call from my machine shop that they were having trouble with the Sealed Power main bearings I had given them. Using a ball tip mike, they showed me that the some of the bearings had a half thousandth or more variance from the left to right side of the bearing. They indicated they...

I am building a 4.1 project with a 291 casting from an 83 regal. The pan has no baffle. What vehicle year/model is likely to have a 14 bolt pan with a baffle? Thanks