Search results

So my drivers side heat shield just decided to fall off. How was this attached as I don’t see any connections points? Thanks.

Anyone use the repo intercooler shroud from Kirbans or GN1? Mine has seen better days. Any feedback would be appreciated.

I did a search to find the center to center (PM Pin location to Vacuum Pin location) placement for drilling the PM pedal to use on a vacuum setup but came up with two results, 1" and 1.5". Can someone confirm which is correct, thanks.

Looking for the proper g-body brake pedal to convert over to vacuum brakes. Let me know price shipped to 77901.

Can someone tell what this plug is that sits right above the console pod, just underneath the radio. Looks as if a light bulb should be in there but not sure. Thanks.

Anyone know where to get or what replace the sump hose with? TIA

Thinking of painting my 86 Dark Blue T a darker shade of blue. Maybe almost borderline black in appearance. Anyone have any pics that may have gone darker from the original dark blue metallic color. Thanks

Do I need to bleed the system to replace the sump hose on the PM unit. Also do the argo parts stores carry this specific hose?

Which filter you guys using right on the end of the LS1 3.5" MAF? I know I'll need a 3-3.5 coupler for my 3" MAF pipe but wasn't sure if there was a way/setup to reuse my existing K&N filter that mounted on the end of the stocker. Thanks

I've noticed several times in stop ang go traffic that as soon as my ATS starts flashing "HOT" on the scanmaster the idle will stumble and then quickly recover. Any ideas as to how the ATS could be causing this or if it's just coincidence and another problem. Living here in south Texas is pretty...

With the HVAC controller set on MAX, should I be getting some air out of the floor vents by the console. I'm getting air through the primary vents as I should, but wasn't sure if some air also came out of the floor vents.

Just installed UMI Tubular Uppers/Boxed Lowers/1" sway bar and rear end housing bushings. Should the sway bar come into contact with the lower tabs on the rear end housing? On the left side there is contact, were as on the right side there is minimal clearance.

Has anyone ever used the rebuilt upper control arms for the front end that come complete with new bushings/cross shafts/ball joints? Any issues with fitment and quality? The reason I ask, is I was about to replace the upper bushings and ball joints with MOOG replacments, but a friend of mine...

Does anybody have a pic on how the spring attaches to the "J" rod in the console shifter to hold it up. I pulled my carpet out and found it laying on the floor. Thanks.

VIN# 1G4GJ1178HP461118...you can send it to bautistaj@ftpc.fpcusa.com Thanks in advance!

1G4GJ1178HP461118 thanks in advance...

1G4GJ1172HP439616......Thanks for the help!

Has anybody seen this color combo on a blue 87 T

1G4GJ1174HP434529......looking into a possible purchase. Thanks in advance.

Could anyone get me a carfax on the following vin#. Thanks 2B3KA53H86H323092