Search results

  1. C

    87 GN roller

    GN to be sold as a ROLLER! Location SE Missouri. $6000 573-931-1004 I want to buy a lower mileage car. My car is a driver and is complete. But this is the best way for me to sell it. Owned since 05 May 1990 with 38K. I am the third owner. I have met the original owner and bought...
  3. C

    Carfax Please

    Please check this for me. 1FMFU18L3BLB16507 craigt@semo.net
  4. C

    Driver's Side Filler Panel

    This is the factory filler panel. I replaced this one several years ago. The other one got replaced several years before that during a fender bender. This one has been out of the sun since it has been put on. It is still flexiable and in great shape. Here are some pics.....Any questions, just...
  5. C

    Modded ECM

    Looking for modded ECM. Shipped prices please.
  6. C

    VIN check for my daughter....

    Thanks in advance...... 1FAFP53U21A141171
  7. C

    Those of you running Convo's

    I want to run 275/60 DR's on the Convo 8.5. How is the fit? I want to keep the car level. Will running the 5" b/s with a wheel spacer help keep them clear on both sides?
  8. C

    VIN check please

    For a truck, 1FTRW08L92KB09214 Thanks in advance.
  9. C

    M&A headbolt PN for 109 Block

    I need the PN for ARP bolts to use M&A heads on a stock block. I ordered the bolts listed for the M&A's but they are for the stage block. PN I ordered is 123-3602.
  10. C

    Question about a 4L60E leak

    My 94 C1500 has a small trans leak at the tail shaft portion. It is coming out of the sensor, which I would guess might be a VSS. The bolt for the tang was tight. Is there an O-ring I can replace?
  11. C

    AC Rapidfire Plug Cross Reference

    Here is some cross reference info I ran across for the rapidfires. http://www.sallee-chevrolet.com/PriceList/group2.041-3.726.html
  12. C

    Spark Plug Socket for M&A Heads

    Those of you running the M&A's. What are you doing for a spark plug socket, my cheapie socket is too thick. Should I just grind it down?
  13. C

    My New Motor Is Ready

    My motor is finally complete. After a blown headgasket trashed my motor with graphite from the stock gaskets, I had it refreshed. The big end of my rods needed a little resizing due to some detonation. Replaced the rod bolts, so we did another balance job. One of my wrist pins was binding...
  14. C

    Breathers for M&A Valve Covers

    I will be needing some breathers for my valve covers. Where can I get them?
  15. C

    Caledit site

    Is the CalEdit site still up?
Top