1986 grand national check engine light (or service soon) light not working
used volt meter no power changed bulb changed connector help cant smog
in california:eek::
Hey guys,
Well, unfortunately my time with the Buick GN has come towards its end but not without trouble. To sum it all up my experience with the GN hasn't been a very happy one although this was mostly due to my lack of any proper budget to get the car running the way it should have (poor...
I really hope it is just a blown head gasket. Shortly after the 19.9 degrees of detonation I found out that my MAF had gone bad and was making the car run extremely lean. I don't know why I didn't figure that out before the run that hit 19.9 degrees. :mad: Anyway, how would I go about doing a...
No, unfortunately I haven't been able to figure it out yet. Haven't had the chance to take it into a shop. I do know my MAF is bad now though, as I unplugged it and the car idled much better.
Picasa Web Albums - royclark24 - Buick Grand N...
This is a level two kit great for your kids first model car. Would look great in your office on your desk at work, home or in your garage.
Make an offer.
Well I found out the reason it detonated was my MAF went bad. I just tested my idle without the MAF plugged in and it runs perfect and purs like it used to. So this was causing some kind of lean condition which caused the detonation. As far as the internals, I'm not sure if it's not running well...
Where is the flexplate located? I was thinking something in the bottom end but there is no noise down there. The car still holds 25 psi of oil pressure at idle and is around 65 during cruise or acceleration. The car has seen knock before above 20 degrees but it's always been at low boost and...
I took it to my mechanic and he just did a brief inspection because his shop was closing at the time but he said the ticking/popping noise sounded like it was external and that he might possibly hear an exhaust leak. I think the exhaust leak he as referring to is my adj fpr which never re-seated...
Hello,
Recently I went to the track and was unable to get any clean runs in because my car wasn't running right most likely due to a bad MAF (car doesn't idle at consistent rpm's). Anyway, on my second run I detonated 19.9 degrees of knock near the top of 2nd gear before I let out running 21...
Ta60: Less than 1000 miles on it but needs a rebuild due to thrust bearing failure according to Limit Engineering. Blades are perfect but there is tremendous shaft play and the turbo leaks oil.
Stock Turbo: Blades need to be rebuilt. Hardly any shaft play and doesn't leak oil. Feels like a...
I have the same ticking noise except it sounds like it's coming from the lower intake manifold. Also, my oil pressure is 25 at idle and 65 at WOT and I always use ZDDP. What could the noise be? It came after a run at the track which saw 19.9 degrees of knock in 2nd gear until I let out.