Recent content by akb4747

hello olds403. there is only one pressure switch, the new location is pressurized in 3rd and 4th. i simply relocated the switch that was already present. andy:cool:

hello all. i got the trans set up for 3 and 4 lockup. this is how i did it on my extreme automatics stage 1. remove plug here and install it here, where the pressure switch is located for fourth only lockup. re-install switch here, where the plug was removed. needed to "slightly...

valve body is BR style i believe, no ECM, non-GM carburated, and am using a lighted toggle switch and relay. thanks, andy

hello all. i want my 200-r4 to have lockup in 3rd and 4th gears. can anyone tell me which port is pressurized in both gears? its a one wire circuit (extreme automatics) with a simple toggle/relay for control. i know i could just ground the wire and have lockup anytime my toggle is closed, but...

hello. i put around 30 miles on the truck yesterday and all went well. 3rd gear pressure switch for lockup was accidentally not installed, but sounds like an easy fix. the stall speed is too high for my purpose and lonnie is going to work with me on that. my engine has a lot of low end torque...

great!! thanks for the quick reply. more to come. andy :)

thanks jayj. i filled the trans today, took 9.5 quarts, i am using a lokar flexible dipstick, so i hope its correct. no TV readings; P-110 R-200 N-110 D-110 3-110 2-325 1-325 lonnies chart says "250+' for 1 and 2 so what should i make of my high readings there? readings are the same with TV...

hello. its been a freaking winter wonderland around here, but i am finally ready to fill the trans and get back on the road. after just a bit of tweaking on the sonnax throttle corrector i have achieved the recommended TV cable geometry (.840 at idle and wot) as per lonnies installation sheet. i...

got the cross member mount done, next is the TV cable installation. andy :cool:

i have been looking at "super-springs" with the rollers. i will have to check the caltracks out. thanks, andy. :cool:

thanks for the replies. keep the advice coming. i have the sonnax throttle corrector kit, and also have Lokar throttle and tv cables. i have read up on the tv adjustment and what i think is correct is, as stated, the wot adjustment, and at idle you don't want the tv cable to "influence" the...

i have a Wilcap adapter kit, but would like to know more about the new bell. andy

thanks, and agreed, you won't see many edelbrocks on serious race cars, but for a "spirited daily driver with short bursts of speed", its a pretty good carb. (plus, its paid for) i have had this one for 20+ years and it is very consistent, easily tuned, and i have gotten most of the "edelbog"...

hello all. i am putting an Extreme Automatics 200-4R behind my slant 6 powered 1984 Dodge D100 short bed.................. ok, now that you have stopped LAUGHING, here are some details of the truck; 1984 Dodge D100 shorty, about 3800 lbs. (i think close to the Buicks?) 1967 slant 6...

thanks all. i am in southern indiana.