LeeRemmos
Member
- Joined
- Jun 21, 2015
After doing some research, I decided to install Moog5660 (with a 1/4 coil cut) in order to lower my front end a tad. I was at 27" to the fender with the stockers and now after install I am 28.5". I wanted to drop to around 26". I know the 5658s are supposed to be lower than the 5660's by an inch but that isnt enough for me since I will still be 1/2 inch higher than I started. And thats not accounting for the 1/4 coil I had cut out.
What should I look for as far as the install being done wrong? Cause I am thinking its a possibility since it raised so much from stock......even though they were probably old and tired, I am thinking its too much of a raise in height for the 5660 to be installed correctly.
What should I look for as far as the install being done wrong? Cause I am thinking its a possibility since it raised so much from stock......even though they were probably old and tired, I am thinking its too much of a raise in height for the 5660 to be installed correctly.