I made these a few months ago. Not completely done yet, but you get the picture.
View attachment 258033 View attachment 258034 .
Bo's parts always lookin good!I made these a few months ago. Not completely done yet, but you get the picture.
View attachment 258033 View attachment 258034 .
Can you fab up some heads that I can change out the head gaskets without taking anything apart?Here you go. I didnt plan on making a bunch of sets, but I do have another set of the same valve covers I could do.
The main reason I did this is because I was tired of pulling the VC off and getting oil everywhere when priming, hearing a possible tick, or adding oil without the hole in the top. I use a canister style breather system and I like a clean look, so this is what I came up with.
View attachment 258246 View attachment 258247 View attachment 258248 View attachment 258249 View attachment 258250 View attachment 258251
5858 for life!Haha! Ya, weld the heads to the block...lol
I have pics with the valve covers installed and getting ready to prime motor. I can adjust valves if needed too, but it would be easier to just take the four bolts out and pull the covers.
Earl is also looking at making some, so keep your eyes open.