1 Bar and 3 Bar MAP wired and mounted, just need to swing by the parts store and grab some Vac/BST lines. Still need to run the high speed fan wire, hook up the WBO2, and Tach.
Pins C16 and B1 are tied together inside of the ECM. It is best to use both but not mandatory.
RemoveBeforeFlight
What about adding the ECM ground to B9, as the pinout states? I will double check the MAP/MAP2 signals at the EBL after work.
I have issue with the 1 bar and have disabled it .at this time just running 3 bar. i am getting a "ses" light let me know what you find. i have not had chance to look into it.DUH. I had both MAP signal wires connected to E14/15, instead of F14/15. The 1 Bar MAP isn't functioning properly, wont run with it enabled, so switched it to use the 3 bar, have a spare to try but I may have pissed off the neighbors tonight, LOL. Video uploading.