Will these fit?

[turbogn_231]

I have an opportunity to purchase a set of Weld Prostars for a pretty good deal but I'm not sure if they will fit.
They came off of a '69 chevelle so I think the bolt pattern is correct?

The rears are 15x10 with 4.5 backspace and the slicks on it are MT 28x10.5.
Will these work on a basically stock height rear suspension? (No air bags)

I dont want to miss out on these and if they fit I will buy them tomorrow. I have Cal tuning on Saturday and a Buick club race day on Sunday that I would like to use these for.
Please let me know if you can confirm that these will work.
Thanks!

Posted from the TurboBuick.Com mobile app

 

[ttypewhite]

They will fit, but your going to have to roll your outer lip so it doesn't shred your tires. That's the same size, back spacing and tires I am running. No spacers required.

 

[turbogn_231]

Crap. How do I do that? And do it before sunday?

Posted from the TurboBuick.Com mobile app

 

[ttypewhite]

hammer........

 

[turbogn_231]

Seriously?


Posted from the TurboBuick.Com mobile app

 

[rmar]

hammer........

Or old reliable...... Baseball bat in a pinch.

 

[ttypewhite]

Seriously?


Posted from the TurboBuick.Com mobile app

Yes sir. Just take your time and do small areas at a time. Don't wind up and wack it with all your force. A heat gun would make things easier if you had one before using the hammer. Just make sure you don't boil the paint.

 

[turbogn_231]

They will fit, but your going to have to roll your outer lip so it doesn't shred your tires. That's the same size, back spacing and tires I am running. No spacers required.

Are these the wheels and tires in your sig?

 

[turbogn_231]

So how do you roll the lip without ruining the trim?

Posted from the TurboBuick.Com mobile app

 

[ttypewhite]

Are these the wheels and tires in your sig?

yes, here is another view.