Tubular Rear Lower Control Arms

RBE17

Behind the trigger
Joined
May 30, 2001
I have a used set of tubular rear lower control arms that have been freshly powder coated black. They are carbon steel and double adjustable w/ rod ends. They are also from a fourth gen f-body so they will fit a TTA. I am not sure if they'll fit a g-body. If someone knows the stock length of a g-body rear LCA I'll be able to tell if these will fit. I'd like $115 shipped to the lower 48 for these.

Thanks,


Steve.
 
Most say 19-1/4" C to C.
From a member on another site:
About the LCA length: I measured two stock LCA's, on both sides of the LCA's. The average of four measurements is 19.31" +/- 0.020".
 
Most say 19-1/4" C to C.
From a member on another site:
About the LCA length: I measured two stock LCA's, on both sides of the LCA's. The average of four measurements is 19.31" +/- 0.020".

Thanks. I'm thinking these might be a little too short for a G-body. I'll have to measure to verify.

Any pics?

I'll try to get some tonight.
 
Here are some pix. Actually, length wise these will fit a g-body. The measurement picture is w/ the start end at zero. It represents end to end not center to center.
 

Attachments

  • P8190004.jpg
    P8190004.jpg
    33.6 KB · Views: 158
  • P8190007.jpg
    P8190007.jpg
    45.3 KB · Views: 154
Top