Tubular front control arm torque?

[fitz3820]

Hi Brian,

I have installed a set of your front upper tubular control arms - is there a specific torque for the nuts on the front and rear? - not the bolts holding it to the frame, the nuts near the grease fitting and the shaft.

Thanks!

-Mark

87 GN 11.9 @ 115

 

[Bweavy]

Mark I'm sure our manufacturer has a torque spoec that I can check on. To be honest when we powder coat them we just back them off . Then when re-assembling we snug them back on then an extra half turn as not to screw up the threads. I'll e-mail them & post back next week. heading to BPG.

 

[fitz3820]

Thanks!

I snugged them up but just wanted to make sure the were tight enough.