Thanks to Buick Turbo Performance (Jim Dunn)

Boostian

Member
Not sure if the feedback section is the right place but after 20+ years of knowing Jim and the work he does I finally had the privilege of sending my car to him. He installed a ton of parts I sent and even had the AC checked and converted to R134. The entire process was communicative, incredibly thorough, and the end result was a completely refreshed Buick with a LOT more power and the comfort to drive around with cold AC in 80* heat while the car didn’t go over 167*. If you are on the east coast, or just want to make the trip to this top-notch experienced Buick specialist, I cannot recommend him enough. His knowledge and attention to detail are things you rarely find nowadays. Thank you, Jim.
 

Buckshot G/N

Active Member
Boostian... You couldn't have gave a much better endorsement in your post. Jim is a walking Turbo Buick encyclopedia. I live 650 miles from the Philly area, and I was turned on to Jim over 15 years ago by Dennis Kirban. I never meet him personally, but I probably done called or text him over a dozen times , and everytime he was friendly and had a answer for my questions. Although he's usually covered up ,you guys on the East Coast ( PA/ NJ) area are fortunate to have such a individual that knows these cars in detail.
 

deezdad

Well-Known Member
Not sure if the feedback section is the right place but after 20+ years of knowing Jim and the work he does I finally had the privilege of sending my car to him. He installed a ton of parts I sent and even had the AC checked and converted to R134. The entire process was communicative, incredibly thorough, and the end result was a completely refreshed Buick with a LOT more power and the comfort to drive around with cold AC in 80* heat while the car didn’t go over 167*. If you are on the east coast, or just want to make the trip to this top-notch experienced Buick specialist, I cannot recommend him enough. His knowledge and attention to detail are things you rarely find nowadays. Thank you, Jim.
Never heard a bad thing said about him, does he work on typhoons?
 

GNICETRY

Cat&wife post starter
There was a guy that used to work at his shop and he brought his Turbo Buick to Kirbans one year. That engine bay was THE nicest OEM looking one I have ever seen. It made an engine bay that just came out of the factory look old.
 
Top